The Roof Replacement Process in Clarksville, TN

We have replaced thousands of roofs in Clarksville. The process is the same every time. Tearo . Decking inspection. Underlayment. Shingles. Flashing. Cleanup. But each step has details

that matter.

This article walks you through the roof replacement process in Clarksville. What to expect

before, during, and after. Call (931) 666-1469 for a free estimate.

Before the Roof Replacement (Step by Step)

The work does not start when the crew shows up. It starts days earlier.

1. Free estimate and contract. We inspect your roof. We give you a written estimate. You

approve. You sign a contract.

1. Material ordering. We order your shingles from a local supplier. Delivery is scheduled for

the day before the install.

1. Permit pulling. We pull the permit from Montgomery County. Cost is included.
2. Scheduling. We give you a rm start date. Weather permitting. We will con rm the day

before.

1. Prep work. The day before, we stage a dump trailer in your driveway. We lay tarps over

your landscaping. We tape o your attic access inside.

1. Vehicle moving. You move your cars out of the driveway. You clear the area around the

house. Nails will fall. Park in the street or garage.

During the Roof Replacement (Step by Step)

1. Tear-o . We strip every shingle. Every nail. Every piece of old underlayment. We throw

everything into the dump trailer. This is loud. This is messy. It takes 4 to 6 hours for an average

home.

1. Decking inspection. Once the roof is bare, we walk every sheet of plywood or OSB. We

look for rot, water stains, and soft spots. We mark any bad sheets with chalk.

1. Decking replacement. We show you photos of the bad sheets. You approve the

replacement. We cut out the old sheets and nail in new ones. Cost is $75 to $150 per sheet.

1. Underlayment. We roll out synthetic felt over the entire roof. We staple it down. Then we

install ice and water shield in valleys, around penetrations, and along eaves.

1. Starter strip. We install starter shingles at the eaves and rakes. This prevents wind uplift.
2. Shingle installation. We start at the bottom and work up. Each shingle gets four nails (six

in high-wind zones). We follow the manufacturer's nailing pattern exactly.

1. Flashing and vents. We install new pipe boots, ridge vents, and step flashing. We seal

everything with roofing cement.

1. Ridge caps. We cut shingles into caps and nail them along the ridge. Each cap gets six

nails and a dab of cement.

1. Cleanup. We run magnets over your yard and driveway. We blow o your sidewalk and

street. We do a visual inspection for stray nails.

After the Roof Replacement (Step by Step)

1. Final walkthrough. We walk the roof with you (or show you photos). We point out the

new features. We answer your questions.

1. Warranty paperwork. We give you manufacturer warranty documents and our

workmanship warranty (10 years). We register your shingles with the manufacturer.

1. Permit inspection. The county building inspector comes out to verify the work. We are

present. You do not need to be.

1. Payment. You pay the remaining balance. We accept cash, check, credit card, or

financing.

Why Hire Clarksville Roofing Co for Your Replacement?

We have done this thousands of times. Our process is smooth. Our crews are experienced. We

communicate. We clean up. We warranty our work.

For Fort Campbell families, we offer exible scheduling. We work around your duty hours. We

also offer a military discount.

Frequently Asked Questions

1. Crew arrival. We show up at 7 AM. We do a safety brie ng. We set up ladders and safety

lines.